Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
I runned RRF with my config in SKR2. (I have 3 external TB6600 drivers connected via STEP/DIR mode and 3 classical EndStops)
After first boot, from two red LEDs, I have left flashing and right on. I connected SKR to Pronterface and I only have some random movements in one of the motors. There is no response to any request.
In parallel, I connect a TTF, but currently it is useless. I only nee
by
xXJRUSHMANXx
-
General
Hello everybody, I'm making polar printer like this one: YouTube
Firstly I tried Marlin, actually I'm trying RRF, but there is no way I can control my machine. I can't even get a correct connection.
Can somebody help me with RRF?
I can give my RRF config if somebody needs it.
Its possible use ArduinoUno with CNCshield?
by
xXJRUSHMANXx
-
General
dekutree64, It is Marlin or RRF??
Do you khnow manipulate polar printer with SKR2 and RRF? I'm trying it but I can't give it.
by
xXJRUSHMANXx
-
Developers
Do you have something? I'm trying same cinematics with SKR2 and RRF but there is no way to control it...
by
xXJRUSHMANXx
-
General
Hello everybody, I'm doing some type of polar printer and there is no way I can control it.
It's about SKR.v2 with 3*nema23 ( Tb6600 drivers) where one of then is an angular moviment. I'm speaking about a custom cinematic.
Actually I'm searching for somebody who can help me with it, I will reward for it.
This project is so important for me, I hope someone can help me.
Thanks
by
xXJRUSHMANXx
-
"Hello, I'm a designer." "I'm an engineer."
I appreciate the help!!!
I did not expect this participation.
It seems that I will be updating my project as time goes by.
About the clock, actually I needn't so much mechanical speed, I hope it's irrelevant in that way. Obviously at the future I will update all my drivers. Hope have no problems with communication.
About Marlin, my idea is to print thinks, so I don't khnow if its so difficult
by
xXJRUSHMANXx
-
General
Hello, I'm trying to make my own 3D printer with 3 nema 23 ( with external TB6560) and an simple nema from ender ( with TMC).
I'm using SKR V2 and I will write own Marlin.
Actually I have some questions:
1) Can I connect my TB6560 to CSL pin-out of SKR? There is only 4 of 6 pins ( Gnd, Dir, Pul, EN)
What jumper configuration I should to have?
There is nobody using external drivers in SKR V2....
by
xXJRUSHMANXx
-
General
