Dear designers/All, I'm building SmartRap and I'm looking for a design to be used as a box for the Ramps board and LCD and it will be perfect if the design contain fan and to have enough space for the wires. Thanks in advance.by yasrkasem - Object repositories
Hi I have the i3 and it's kinda more pro than fun, did you checked the SmartRap? easier to build, less parts, assembled from plastic, easier to operate and use (from my opinion). good luckby yasrkasem - General
tweeking and more calibration is going on, the result getting better after changing the printing settings, I will update more photos when available, guys thanks for your comments.by yasrkasem - General
Hi all, after 10 days waiting my printer and another 3 days assembling it, finally I got my first full print out (Attached), the reason I said full print because there were few failed attempts before I calibrate my printer, the attached photos for the hollow cube 25mm, the X,Y & Z are calibrated and the cube size is accurate, The walls are 4mm width (not in all part as you can see in the photby yasrkasem - General
Hi, If you using a computer ATX PSU, Add some load on the 5v output as some ATX shutdown if no load on the 5v.by yasrkasem - General
Hi, As Cat.Farmer said, (expected size)/(actual size) * current setting = value for steps But, you don't have to print and measure you can just move the X, Y & Z from the printer interface to 100mm from home and measure the actual movement then apply the formula. mostly the X & Y will be the same value but the Z is different. for the E, Just extrude 100mm and measure it on your caliper,by yasrkasem - General
السلام عليكم انا فى الامارات وبجمع اول برنتر لو حد ممكن يساعدنى فين ممكن الاقى فيلامنت فى الامارات؟ او حد حابب يشارك خبراته شكرا مقدماby yasrkasem - Arabic RepRap User Group
That's great, thanksby yasrkasem - General
Hi all, Just wanna thank every one writing and contributing in this forum as it helped me a lot to understand the reprap and 3d printing. My question is, I'm building my first 3D printer from makerfarm (prusa i3 8") and it's not coming with kapton tape and didn't find it any where so far! But, I found this it's a silicone tape high resistance to high temperature up to 260C. Can I use it to iby yasrkasem - General
Yes they shipping worldwide, just go to the web site, choose the printer, add to card, then you can estimate the shipping cost to any country with shipping options. They shipped my kit to the UAE, Dubai with 125$ USPS express mail.by yasrkasem - Reprappers
you might change only the heat block for the hotend to another one 12v and you done, after every thing come ok and your printer tuned you may upgrade it to 24v as mentioned.by yasrkasem - General
Nice finishing, will doneby yasrkasem - Look what I made!
Very good designby yasrkasem - Look what I made!
I ordered a full kit from Makerfarm and will arrive to me in few days.by yasrkasem - Reprappers