Good Day I can see that it looks like the manufacturer has changed the design of the printer and that is to bad as the design I purchased has been working very well, I knew going in that I would have to mod a few things to make it better but for me that is the fun part, I might have been lucky but mine has been great. Here is a picture in its current config. thanks to the crew over at Thingiversby Tatsudoshi - Extruded Aluminum Frames
Good Day Well I have the Flsun I3 working pretty well now, the longer lead screws work fantastic, nice and solid and I was able to get about 250mm height for print area. This is a great kit that is easy to upgrade, and I am a total newbie to the whole 3d printing thing, much more learning to do. Take Careby Tatsudoshi - Extruded Aluminum Frames
Good Day Well after looking at all the brackets to hold the lead screws more secure, I noticed that the top brackets that come with the Flsun I3 to support the two Z axis stainless rods also have a 8mm counter sunk hole opposite each other that would support the lead screws if they were longer, so I bought two 8mm lead by 2mm pitch (same as factory) lead screws 400mm long and cut them to 368mmby Tatsudoshi - Extruded Aluminum Frames
Good Day Everyone I just wanted to post that I have picked up this kit and so far in the build it is ok except I had to add another set screw for the X axis, one on each side now and she is pretty solid. I just wanted to add that this forum has been a wealth of knowledge as I am a total greenhorn to 3D printing. Take Careby Tatsudoshi - Extruded Aluminum Frames