Cameron, Thank you very much for your help! This is exactly what was needed. All carriages now are moving uniformly. For the benefit of folks reading this later, the board was made by Geeetech and IS NOT the one made/sold by Ultimachine. Thanks again for your help. This is a fantastic community. Valby valNuts - Delta Machines
Hi folks! I'm trying to commission a new Delta printer and am struggling with a problem wherein whatever motor attached to either of RAMBo's Z dual drivers will move the carriage at a faster rate than X,Y carriages. The printer will home normally most of the time on the G28 command. However, issuing a relative by 100 units command (G91 G1 Z-100 F1000) will result in X and Y travelling the correctby valNuts - Delta Machines