Show all posts by user
Rostock, Kossel, Simpson, 3DR, and more. See: http://reprap.org/wiki/Category:Delta. Previously named "Delta Robots and Stewart Platform"
Re: FSR Autocalibration Issue - 9 years ago
I have fixed the issue - thank you.by [email protected] - Delta Machines
Re: FSR Autocalibration Issue - 9 years ago
Thanks for the Reply Olaf. I am a little confused by the reply though. My delta has X-MAX, Y-Max, and Z-MAx endstops at the top and nothing on the bottom. There are the three FSR plates under the heated bed acting as X,Y,Z min i suppose? In my config.h file I have the following defined: // The pullups are needed if you directly connect a mechanical endswitch between the signal and ground pinby [email protected] - Delta Machines
FSR Autocalibration Issue - 9 years ago
Looking for help/advice please with my Delta build Autocalibration issue. running Arduino 1.0.6 / Ramps 1.4. With FSR Autocalibrate I get the following error. Any suggesitons would ne greatly appreciated. Printer is now online. echo:Marlin 1.0.0 echo: Last Updated: Sep 25 2015 18:39:09 | Author: Rosen Compiled: Sep 25 2015 echo: Free Memory: 2527 PlannerBufferBytes: 1232 echotored settings rby [email protected] - Delta Machines
Re: New Mini-Kossel Setup Help - 10 years ago
thank you all so much. I am fairly calibrated and exerything appears to be working except for one major problem.... I can not get my PLA filament to actually print. I spent a few hours today trying everything I could. I set my temperature as high as 235c with no results. If I push very hard on the filament I might get a tear-drop out but then nothing but resistance. What am I doing wrong?by [email protected] - Delta Machines
Re: New Mini-Kossel Setup Help - 10 years ago
Thanks for the reply. 1. Yes using Marlin 2. Fan is connected to D9. It works with the manual M106 and M107 commands, just will not go on automatically when I start a print or after hot end reached 50 deg C.by [email protected] - Delta Machines
Nema 17 Motor adjustment on Kossel - 10 years ago
Quick questions for the forum. 1. Will a metallic screw driver damage the stepper drivers if used to adjust the potentiometers while hot? If so where do you get a non-metallic driver locally? 2. My nema 17 stepper motors have a high pitched whine to them and when I home they make a pitch noise even after the slides hit the x, y, and z max limit swiches. What is the best means to adust this ifby [email protected] - Delta Machines
New Mini-Kossel Setup Help - 10 years ago
Hello. After struggling with this new build for days I am throwing in the towel and I could really use some assistance please. I have a MiniKossel running on Arduino 1.0.5, RAMPS 1.4, Slic3r 1.1.7, and MacPronterface Mar 10, 2014. For the life of me I can not get the printer calibrated and configured correctly. I am having these issues: 1. Hot End Fan will not enable automatically 2. Loadby [email protected] - Delta Machines