Show all posts by user
Rostock, Kossel, Simpson, 3DR, and more. See: http://reprap.org/wiki/Category:Delta. Previously named "Delta Robots and Stewart Platform"
Weird vertical striations that only appear on Y axis. - 8 years ago
Hello all, I've replaced my linear bearings with igus polymer bushings on my Y axis and added the Z-Brace mod on my Wanhao Duplicator i3 and ever since I've had these weird vertical artifacts... I've made sure all corners are the same height from the table, all rods are tight and true, same for belts... Any ideas are greatly appreciated. Cheers, Tomby freshpine99 - Printing
Re: Using Melzi v2.0 control board for delta. - 8 years ago
Never thought of that, will read into it. If you've seen any examples of people who have done similar, please show me if you can!by freshpine99 - Delta Machines
Using Melzi v2.0 control board for delta. - 8 years ago
Hello all, After owning a couple of Duplicator i3's for a while, I have spare Melzi 2.0 board which I'd like to use to control a delta printer. However, I've thought of an issue regarding bed levelling. Obviously I can't replace the Z-endstop with a sensor because the 3 axis' each require their own endstops, the Melzi board only has room for 3... How could I go about implementing auto bed levellby freshpine99 - Delta Machines
Re: Migbot Prusa i3 Unofficial Support Thread - 9 years ago
Hello, I've fixed the LCD. It was the cables. However I'm now getting the trouble with getting the motors to move. Edit, I think it may be the power supply. The square fan which is hooked directly to the 12v isn't spinning up.by freshpine99 - Prusa i3 and variants
Re: Migbot Prusa i3 Unofficial Support Thread - 9 years ago
Hello, I'm going to apologise for my newbness beforehand. I've bought and assembled this printer and plugged it into my PC. It's installed the automatic drivers but I'm unsure where to go from here. The LCD screen does not turn on, the power supply fans spin up and the red LED on the board lights up to say it has power. Any attempt at using a slicing software says the printer is offline regby freshpine99 - Prusa i3 and variants