Quotedavidf01 So I think I'm missing a connector. The directions say "For the thermistor wires we need to wire them to a connector. Strip the end of the wire back approximately half and inch and repeat the process for the short pig tale wire that came in your kit." I dont have a connector to do that with. Did anyone else have this issue and what did you do about it if you didn't call Folger?by DGreen - Delta Machines
I had this issue last night using Pronterface for the first time. My XYZ offsets and home positions were not grayed out and I was able to put in an X/Y offset of -75 with X/Y home pos. of 75. This centered my print. Not too helpful for figuring out why you don't have that option, but that is how I solved the offset.by DGreen - Delta Machines
So customer service did respond back to me and they are sending me more m4 t-nuts as well as the correct plastic piece for the extruder. I'm happy with the customer service, but both of these problems wouldn't have required me contacting them if they had any amount of quality inspection before shipping. New problems.... 1. The build guide on page 19 says to mount the effector using 4 M3x25 bolby DGreen - Delta Machines
So my Folger Tech Kossel kit came in the mail the other day and so far I'm pretty disappointed. They didn't supply me with enough t-nuts and then this... Anyone else with the kit noticed this black plastic piece being backwards? Notice where the feed hole is compared to the brass fitting. I can't flip the machined aluminum around because it's asymmetrical and I can't flip the plastic piece arounby DGreen - Delta Machines