Quotepaul_delta PS: probably you did it already, but just in case... check 3 jumpers under driver boards. Quotejbman Quotepaul_delta Quotejbman I tried the test software. X & Y are not working. Swapped stepper motors - X & Y work Swapped drivers X & Y to Z and E, Z & E still work - dirvers ok It appears to be the X & Y channel on the RAMPS - The X powers and holds location, tby jbman - Delta Machines
Quotepaul_delta Quotejbman I tried the test software. X & Y are not working. Swapped stepper motors - X & Y work Swapped drivers X & Y to Z and E, Z & E still work - dirvers ok It appears to be the X & Y channel on the RAMPS - The X powers and holds location, the Y doesn't power. I'm thinking it's the RAMPS board, do you think I should get a Mega also? I saw some people had bby jbman - Delta Machines
Quotepaul_delta Load test code instead of firmware: PS: hope you don't switch motors when everything powered on Quotejbman Hi guys, I have just finished putting together my Kossel Delta and I have tried to start the calibration. I have tried several of the configuration.h files/ builds Marlin & Repetier in this thread, but every time i try to home (G28) only the Z will go to the stop anby jbman - Delta Machines
Hi guys, I have just finished putting together my Kossel Delta and I have tried to start the calibration. I have tried several of the configuration.h files/ builds Marlin & Repetier in this thread, but every time i try to home (G28) only the Z will go to the stop and the other 2 axis don't move. I have tried the other stepper motors on the Z- plug on the RAMPS and they work. I have triedby jbman - Delta Machines