Show all posts by user
Rostock, Kossel, Simpson, 3DR, and more. See: http://reprap.org/wiki/Category:Delta. Previously named "Delta Robots and Stewart Platform"
Re: Folger Tech Kossel Delta 2020 Full 3D Printer Kit w/Auto-Level - 10 years ago
QuoteEvilBetty Still having some problems with filament leaking in strands during preheat, usually curling up into the side of the nozzle. Any suggestions for dealing with that? Was happening even at 205c, I had this problem for a while -- I solved it by cleaning my nozzle. Sitting it on the edge of the flame from a gas stove burner for... 20 minutes?by Dav3xor - Delta Machines
Re: Folger Tech Kossel Delta 2020 Full 3D Printer Kit w/Auto-Level - 10 years ago
I've been printing with that same pale green on my printer -- 185 temp, 5mm retraction works pretty good for me. My heater plate had a little bow in it; I figured out it's geometry, and with a careful and studious use of my foot, and a copy of Bill Shatner's autobiography (hardcover), I was able to make it as flat as my cheap metal ruler and a bright light source could measure.by Dav3xor - Delta Machines
Re: Folger Tech Kossel Delta 2020 Full 3D Printer Kit w/Auto-Level - 10 years ago
Aha, perfect, thank you. That was the impression I got from reading the few things I could find, but it was hard to be sure.by Dav3xor - Delta Machines
Re: Folger Tech Kossel Delta 2020 Full 3D Printer Kit w/Auto-Level - 10 years ago
Hey There. Joined the forum to ask a question... I bought a kit back in November, I have it up and running reasonably well printing off my computer. Happy with my kit so far, I stumbled my way through a few pitfalls while building it, my only major modifcations from stock being an e3d-lite6 print head (it's awesome), and I removed the bed sensor and it's bracket (because as everyone here sayby Dav3xor - Delta Machines