Hey DannerD3H, did you ever figure this out? I've I'm the exact same boat and losing my mind. I have 5 years printing experience and owned over 4 different machines but this is kicking my ass.by robschwieb - Printing
Thanks for the clarification guys. It finally clicked when I imagined the joint at a 90 degree rotation.by robschwieb - Delta Machines
QuoteThe rod length should be the distance between the centres of the balls ignore the cup bit just measure the centre to centre of the balls once it is all assembled (I suspect you are 10mm to long in your config) I've seen this stated elsewhere but no real facts to back it up? Why would it be from the center of the ball, I could see if the counter sunk magnet was 5mm deep and covered half ofby robschwieb - Delta Machines
Hello everyone, I've been lurking and using the great resource that is this forum ever since I built my i3 last year. Well, delta calibration has kicked my butt enough that I actually had to make an account and post Anyway, I know I have to be missing something obvious but I've gone over this stuff time after time and I still can't figure it out. I think it might have something to do with the vaby robschwieb - Delta Machines