Thanks Maso, You're right, it was a typo. The Y was reading correctly. What I think was happening was that my carriage wasn't hitting my endstop switch reliably, but my finger was. So using the M119s showed correct functionality it was my carriage not adjusting correctly. I finally understood to adjust the endstop so the carriage hits it better and now it's finally working. Thanks all forby PaulM - Delta Machines
Thanks Sir Death, I should have double checked the attachment. My bad. So I spent a lot more time with M119s and I found out that I did have one endstop a smidge higher than the other two, but it was clicking. Adjusting it made me accidentally come on an odd scenario. When I adjusted the end stop that was given me a hard time and then homed another axis ran into the same issues. (Mash theby PaulM - Delta Machines
Hello All, I just put together my first 3d Printer. A Micromake delta 3d printer with the linear slide rails and a heated bed. I copied the Configuration.h file from the Micromake thread and its attached. Every time I home the printer two of the towers home fine (X and Z) and then one (X) just skips on the stepper when it gets to the top. Because of this I really can't move onto any ofby PaulM - Delta Machines