finally I levelled my micromake and the hotend can go up to 200 degree now... now new problem... the print won't stay on the bed. the bed is glass, after a while, it shifts.... I tried to apply paint tape on it, print sticks to it, but the tape also sticks to print and almost impossible to remove the tape. I used the painter;s tape bought from dollar store. Any recommendations for the bed? tby brisk - Delta Machines
found the problem max pid was 175, changed to 255, and it workedby brisk - Delta Machines
Anyone know the temp sensor type? I use 5, but temp only reaches 192, tried pid tuning, but reaches 195, then failed (timedout) This is my pid setting //=========================================================================== //============================= PID Settings ================================ //=========================================================================== // PID Tuniby brisk - Delta Machines
I just run PID tuning command: M303 E0 S200 C8 It reaches 195 then wouldn't go up anymore and consoles says timedout, pid tuning failed. this is my current pid setting: //=========================================================================== //============================= PID Settings ================================ //====================================================================by brisk - Delta Machines
Hi, my hotend won't go up to 200, only to 193 degree. I am wondering what is the correct sensor type? I am using 5: 100K thermistor, ATC semitec 104GT-2 My printer is Micromake, firmware is latest Marlin RC, I downloaded Micromake's old marlin firmware, it is also 5.by brisk - Delta Machines
Thanks!by brisk - Delta Machines
Hi, All I am new to 3d printer. Just assembled my first delta printer (micromake). Now I am having problems levelling it. The stock firmware has auto calibration feature, but it didn't work for me, it shows calibrated, but when I print, the hotend is too high at x direction. So I installed latest Marlin 1.1 RC, I followed this steps: 1: find the center of the bed, mark it 2: adjust the stopby brisk - Delta Machines
Hi, everyone, I bought a micromake too! But I am having problems. This is my first 3d printer, so I don't have too much knowledge about it :-( So, I assembled the printer by watching youtube videos, I run the auto leveling from the crua and it worked, however I have the following problems: 1: when doing the auto leveling, I can see when the hotend touches the bed, it slides a bit then I hearby brisk - Delta Machines