QuoteNTTD QuoteNTTD I did have one issue, the bowden tube supplied was damaged by being zip-tied too tightly permanently putting a kink in it. It also was not Teflon (PTFE) it's some kind of clear plastic (PTFE is opaque white). I was having bad prints until I figured out that this was the issue. I purchased a new PTFE tube from Amazon and immediately was able to print after installing it.by NTTD - Delta Machines
QuoteNTTD I did have one issue, the bowden tube supplied was damaged by being zip-tied too tightly permanently putting a kink in it. It also was not Teflon (PTFE) it's some kind of clear plastic (PTFE is opaque white). I was having bad prints until I figured out that this was the issue. I purchased a new PTFE tube from Amazon and immediately was able to print after installing it. I let theby NTTD - Delta Machines
Quotestamos It is good to see that they improve quality and take care of some issues. Nice report. Is it easy to post some photos of your prints? This was one of my first prints after calibration. This one was a bit later as I dialed in the settings. I'm getting some good prints now.by NTTD - Delta Machines
QuoteHarshReality I have gotten this (linear plus model) and finished assembly last week.. Set Z height then end stops (when working X it seemed to be a little off center from the numbers in the video so might have to do that again) and did a calibration cube. Looked thin.. almost transparent. The glass has an adhesive surface that works well with PLA but after alot of issue removing I think I wiby NTTD - Delta Machines
I just put one together two weeks ago, I hear they have been improving the kit as they go, I have had some different experiences than Siddharta and thought I'd chime in. Quotesiddharta - The packaging it arrived in is the best I've seen so far. Everything is really well protected, shipping damage is unlikely. - Same experience here Quotesiddharta- All parts and screws are well labeled and tby NTTD - Delta Machines