Hello, I have 2 motors of this in Y axis And I have 2 TB6600 and 1 x TMC2208 Which controller should I use and what configuration? Best regardsby raspdroid - Controllers
Thanks Dust, I have changed S0 to S5 and now works perfect. Best regardsby raspdroid - Laser Cutter Working Group
Hello, I'm using a 2.5W blue laser. It's ok for lines but when are dotted not print well because It takes a long time to turn on and off. I'm using M4 S0~255 for ON and M4 S0 for OFF. If the speed is high, the laser does not turn on. And if the bass comes on but then the long lines come out very thick. Is there no way to balance this? Best regardsby raspdroid - Laser Cutter Working Group
Works but this plugin works better It's a fork I beleive but has more resolution and more features. But I get real size only with 10px, with 20px or 50px the image is resize.by raspdroid - Delta Machines
Ok, I found this, I'm going to try it.by raspdroid - Delta Machines
Hello, I have added a laser a my kossel delta plus, works fine but the Z goes up aorund 1cm when move to the left and goes down when move to the right. I'm using Raster 2 Laser Gcode generator plugin for Inkscape. That not occurs with Cura (3d printing). The result is that one side is more engraved than the other. Is there any way to solve it? Best regardsby raspdroid - Delta Machines
Not works to me. Then I tried to solder the wire to the led in the FAN_PIN_0 and now works perfect. And not is necessary to set the P. Thank you and regardsby raspdroid - Firmware - Marlin
Thanks for the replies, I have try with "M280 P0" The servo0 pin but not works to me, the laser is always on. @VDX I'm using Raster 2 Laser GCode generator, Inkscape plugin, I need put the command in "Laser ON Command" and if I select Gray Scale the plugin generate this: ; Generated with: ; "Raster 2 Laser Gcode generator" ; by 305 Engineering for Lasersaur ; ; ; G21; Set units to millimeteby raspdroid - Firmware - Marlin
Arduino pin 12 if not used and is pwm pin In this firmware is #define PS_ON_PIN 12 other pwm pins that are not used are: #define SERVO0_PIN 11 #define SERVO1_PIN 6 #define SERVO2_PIN 5 #define SERVO3_PIN 4by raspdroid - Firmware - Marlin
Yes is that board ATMEGA256016AU Pins D42, D43, D14, D3 and all servos are not used. The laser is thisby raspdroid - Firmware - Marlin
Hello, I have a Trigorilla ATMega2560 board in a 3d printer with Marlin, I have printed this part in order to use a laser with pwm. Arduino code is here The laser has 3 pins, VCC (12V), GND and PWM, VCC and GND are connected to the 12V power supply output but where I can connect the PWM pin? Best regardsby raspdroid - Firmware - Marlin