Hello GrAndAG, Thanks for finding this design on thingiverse. It worked out great for me. I used the customizer, and made a fan-shroud that fits perfectly on my Sintron hot-end. I set the barrel diameter to 19.5mm, after measuring mine with a calipers. The customized design can be downloaded at: This design cools the hot-end heat-sink barrel much more effectively, hence the nozzle heats upby gkr - Delta Machines
Yes, I had printed the fan-duct from the e3d design (http://www.thingiverse.com/thing:340312) last week, while I was waiting for a e3d v6 lite, that I had ordered on amazon. But when I tried to test fit it to the Sintron hot-end heat-sink barrel, it did not fit (second picture attached). E3D has included a "V6.6_Duct.stp" file, along with the STL file, But it appears that these STP files can onby gkr - Delta Machines
Hi ohfurryone, I have attached the requested Carriage STL files. Regards.by gkr - Delta Machines
Thank you, Tha Reaper. Your quick response is much appreciated. Regards.by gkr - Delta Machines
Hello Everyone, Can anyone please measure the resistance between pad-1 and pads 2+3 on the Aluminum Heated print-bed, and let me know? I have measured mine, and it appears to show a resistance of about 2.5ohms. Wanted to compare with others and see if its comparable. Thank you very much in advance. Happy New Year!! Regards.by gkr - Delta Machines
Hello DRTak, No worries. Regards.by gkr - Delta Machines
Hello DRTak, Are you based in the US? And are you looking for the parts attached in the picture? I have one set ready printed on my other 3D printer (as seen in the picture). Finally, how many do you need? If you are in the US, I can probably print a couple of them and mail them to you via USPS. Not sure if that would help you get back on track, any faster. Please let me know. Best Regardby gkr - Delta Machines
Hello, I am using the Marlin firmware that Sintron provided. I then made the modifications to the configuration.h file, as attached above. There is a link to it in one of the older pages in this thread. Let me know if you can't find it, I can dig through my e-mail exchanges with Sintron and provide you the DropBox link. As far as the Slic3r 1.1.7 config goes, I configured that myself (by trialby gkr - Delta Machines
Hello DRTak, Thank you. The "qbert" thing you were talking about is this: Since I built my first 3D printer (A PrintrBot Simple 2014), I have used the above design to calibrate all of my 3D printers, and I have had good success (at least as an initial starting point). And the Delta printers are a whole different beast!! I'm nowhere being anywhere near perfect with my Sintron Kossel yet, butby gkr - Delta Machines
Hello All, This has been a great forum, and I have learned a lot here over the past week or so during the course of my Kossel build (especially during the tuning and calibration process). Built the printer entirely using the parts that Sintron shipped in the box (besides the fan-shroud, which I printed on my other 3D printer, as the Sintron design was coming in the way of one pair of diagonal rby gkr - Delta Machines
Hello, Thank you for providing a link to this part on Thingiverse. I had a problem where one of the diagonal-rod ball-ends binding with the original built-in fan-mount. I printed this one, on my other 3D printer, and it installed fine, and that solved my binding problems. regards.by gkr - Delta Machines