Thank you. Solved the probe. It works how it should now. It was sticking. But after it autolevels, the hotend doesn't move parallel to the bed. When moving away from the center towards any of the pillars, it also moves up. I played with the smooth rod offset, but i'm not getting it right. i measured 161.5mm. this value doesnt't work. also tried 159 to 175. no good. any suggestions?by CrisCG - Delta Machines
i have a induction probe on order, but that will arrive in 3-4 weeks.by CrisCG - Delta Machines
Thank you for your reply. It's sticking... you mean that the probe's support shaft is to narrow, so the allen key isn't moving easely? It might be. That part was printed with wrong dimensions, at first the allen key wouldn't fit in there at all. i made it fit, with a knife, scraped the walls. might need a bit more. i tried manual calibration, using this method. I adjusted the endstops offset fby CrisCG - Delta Machines
This is what's happening: look hereby CrisCG - Delta Machines
with the probe deployed m119 command shows z_min: open with the probe retracted m119 command shows z_min: TRIGGEREDby CrisCG - Delta Machines
Hi. I just bought this kit a week ago and i now have it all built. The fan doesn't seem to work. I am folowing the calibration procedure they supplied in the pdf. I can set the maximum and minimum z axis coordinates. After that, i am asked to deploy the autoleveling probe. I manually deploy the probe. I home the printer and then i hit the g29 command. The print head, goes down almost till itby CrisCG - Delta Machines