Show all posts by user
Rostock, Kossel, Simpson, 3DR, and more. See: http://reprap.org/wiki/Category:Delta. Previously named "Delta Robots and Stewart Platform"
G0 /G1? - 5 years ago
Marlin firmware, repetier host software, prusa I3. In repetier exist 5 buttons that we can program to execute g codes. I have a few set to home all and auto level, but I like to keep my bed straight too. To facilitate this I wrote a gcode to allow me to focus just on the bed and not on moving things. The goal is to use G1 movement and G4 dwell commands to run me to a corner, wait 15 seconds, runby clearlynotstefan - General
Re: Z Probe v. Auto bed leveling??? - 5 years ago
I assumed so, but it doesn't seem to work that way in practice. I calculated my Z offset in repetier, set it as my firmware z offset. When I home the bed (with the probe in the center [100x100], then move the nozzle to the same point and lower it to 0 it is a perfect clearance. Then I run G29, it probes its 4 points, then if I move the nozzle to the center and bring it to z0 it'd smash into the bby clearlynotstefan - General
Z Probe v. Auto bed leveling??? - 5 years ago
First post out of what I assume will be many. Hope you guys can help me out. I can't seem to figure out auto-bed leveling on my machine/firmware. I guess I don't understand the relationship between Z probe settings and Auto-Bed settings. First my info RepRap Guru Prusa I3 Acrylic Marlin Firmware Repetier Host- Slic3r built in for slicing. The firmware that came with the machine was marlin pre-bby clearlynotstefan - General