QuoteQuoteI was able to connect the board to my PC using USB, so this seems to be OK. Honestly, it's a relief to read this. The same worked for me three times without failure, so I released the design, but would it work for everybody? Apparently yes, and I'm happy with it. Even more good news :-) I was able to upload firmware using USB. QuoteQuote2. ATmega pin 7 is ~1.1V, is this ok? I thoughtby Ericisko - Next Wave Electronics Working Group
Hi, I built Gen7 1.5 and doing checks as described on Gen7 1.4.1 page, there are few possible issues. I want to make sure everything is OK before plugging in ATmega. These are the 'issues': 1. ATmega pin 14 is high. I assume this is OK since it is connected to TX pin of MCP2200. 2. ATmega pin 7 is ~1.1V, is this ok? I thought all the pins should be below 0.5V unless at 5V. 3. All my 5V measureby Ericisko - Next Wave Electronics Working Group