Hi. Can anyone tell me what are the things to do to get Repetier firmware to work on Gen7 1.5? Any particular tutorials I can follow? Thanks!by wickedweed73 - Next Wave Electronics Working Group
Managed to burn the bootlader over the weekend, uploaded teacup and connect the board to replicatorG. What I did was use an arduino duemilanve as an isp and n added the gen7 20mhz bootloader file name into the sanguino boards.txt and copied over the .hex file to the sanguino folder. I havent bought the pololu drivers yet. Is there a way to hook up to a 2M542 driver to test since I already have itby wickedweed73 - Next Wave Electronics Working Group
What I did was to use the Sanguino bootloader, added the following to the boards.txt file and burn the bootloader. What should the baud rate be for uploading the Teacup firmware via USB connection on the Gen 7 board at 20MHZ? ############################################################## atmega1284p-pu.name=Sanguino W/ ATmega1284p 20mhz atmega1284p-pu.upload.protocol=stk500 atmega1284p-pu.upby wickedweed73 - Next Wave Electronics Working Group
Do I have to use a 20mhz crystal when breadboarding to use arduino isp to upload the sanguino bootloader?by wickedweed73 - Next Wave Electronics Working Group
Hi. I've just built the ver 1.5 and I'm trying to upload the Teacup firmware onto the atmega1284P and facing difficulties in uploading the firmware. Here is what I did: 1) Used an Arduino Duemilanove (atmega328P) as Arduino ISP and burn the bootloader onto my 1284P following instructions here: 2) Configured the MCP2200 to have the blinking LEDs using the Microchip configuration utilityby wickedweed73 - Next Wave Electronics Working Group