Justement j'ai vérifié ! Entre deux fils j'ai une certaine résistance, sur les deux autres rien... Je voudrais voir si il y a pas un défaut au niveau du fil à l'intérieur du moteur...by Tibow - RepRap Groupe d'Utilisateurs Francophone
Bonjour, Je soupçonne un de mes moteurs NEMA d'avoir un problème au niveau des bobines... Je voudrais l'ouvrir pour vérifier ça mais je n'y parviens pas ! J'ai retiré les 4 vis de 40mm, mais après pas moyen de l'ouvrir, y a-t-il une technique particulière ? PS : référence du moteur : 42BYGHW811 Merci d'avance et bon dimanche !by Tibow - RepRap Groupe d'Utilisateurs Francophone
Thanks Traumflug ! Yes, I used a PC with Windows 7 - 64 bits... So I've tried with another PC with Windows Vista - 32 bits : and it works ! I can upload the test firmware, without reset manually the gen7 ! And I can also upload marlin firmware ! But with vista, I've another problem : I can't run repetier-host software... when I run it, it crashs : "Repetier-Host stop working" A problem alwaysby Tibow - Next Wave Electronics Working Group
Hi twistedrerap ! My chip is a 644 - 20MHz... The first time I power up the electronic, I upload the test firmware : And it worked well ! Then I tried to upload Teacup firmware, impossible... Marlin, impossible...Even the test firmware, I can no longer upload it... And didn't try to upload any bootloader.by Tibow - Next Wave Electronics Working Group
Hi ! I've started building a RepRap Prusa Mendel, and i'm using Gen7 for the electronic... My trouble is that I can't upload a firmware to the Gen7... The upload takes a long time and in about 10 minutes there are a couple of error (e.g. Time out). I read that it could be an autoreset problem, but even though I reset manually just before the upload, I have the same problem... And I tried witby Tibow - Next Wave Electronics Working Group