Hallo Leute, ich habe eine Maschine gebaut mit 500x600mm Druckfläche und möchte diese vor jedem Ausdruck mit G29 automatisch leveln lassen. Dazu hab ich einen kapazitiven Sensor eingebaut und dieser gibt auch Signal an der Glasoberfläche des Bettes. Z Offset habe ich noch nicht eingespielt da ich erst einmal die Grenzen und das Muster einstellen wollte, welcher der Sensor beim G29 abfährt. Funktby Pepejans - Allgemeines
I builded a bigger cartesian Printer with a glasplate of 600x500mm and wanted to use autobed leveling (bilinear grid of 3 x 3 points) with a capacitive sensor on a Rumba board. The sensor reacts Right and I can home perfectly. The Problem is that everytime I run the G29 command the sensor is moved over a grid of 3x3 = 9 Points. In the first 3 Points of the line the sensor detaches the glassurfacby Pepejans - Reprappers
Hallo 3d Freunde, ich habe eine Mendelmaxmechanik 1,5 gebaut mitsamt Opto Endstops, Megatronics 2.0 etc. Erste Programmierung hab ich auch hinter mir in dem Sinne, daß die Endstops richtig eingegeben sind und der Drucker schon mal auf Y und Z Achse mitsamt Pronterface verfährt. Heizbett und auch Hotend heizen und es bewegt sich auch der Filamentvorschub. Frage ist, obwohl ich die gleichen Einsteby Pepejans - Allgemeines
Dear Builders, after some discussions with the technical service from Reprapworld I found now the missunderstandings after everything works fine. I tried to get the following bundle running: Megatronics V3.0 Board together with blanc LCD2004 originally from Reprapworld. First of all: In the megatronics data guide is described the PINs from 1-12. Some PINS for LCD are described as LCD4 as an exby Pepejans - Next Wave Electronics Working Group
Hi Rigor, To explain clearer I want to give you the steps I did by myself: 1.) I'm using the purely LCD2004 without any encoder or anything else originally from Reprepworld 2.) PIN description from Megatronics V3.0 PDF says for LCD support; PIN1 GND PIN2 5V PIN3 LCD Contrast PIN4 D32; (R/S on LCD) PIN5 GND; (RW on LCD) PIN6 D31 (Enable on LCD) PIN7 D14 (Data 4 on LCD) PIN8 D30 (Data 5 on LCD)by Pepejans - Next Wave Electronics Working Group
Thanks first for your fast answer; if I do exactly what you described then only comes brilliant blue screen with nothing on it although I was running serial monitor from the megatronics testsoftware. I also looked in PIN configuration of the marlin file, no help, so I hope that reprapworld can help me where I bought everything. The documentation of LCD2004 and board megatronics V3 in terms oby Pepejans - Next Wave Electronics Working Group
Hello, I'm building a Mendelmax 1.5 with Megatronics Board V3.0 and trying to get LCD 2004 running on this board. Does anyone has a wiring diagram which pins needs to be connected from the board to which pins on the LCD? I know that this is described in the forum with standard ramps, but not with the pins of the megatronics V3.0. I tried a version of LCD to megatronics V2.0, because I found thisby Pepejans - Next Wave Electronics Working Group