Show all posts by user

no response at reprap host program. - 14 years ago

Hi, i had a problem in a reprap host program. When i try to run a XYZ axis position to test my mendel than my computer was getting dead (no response) at that time when i was click a "go" buttom in the XYZ control winodws. Can anyone can tell me what is the problem ? My computer setting as follows. 1.) I was follows and I did a "Select Preferences->Globals->CommsDebug " and i didn't found

by tv7957ht - RepRap Host

Re: Uploading 'ArduinoSlaveExtruder' to extruder board error - 15 years ago

Do you mean just turn the USB/TTL cable which is a side connected to extruder board upside down as normal ? if i plug that cable to extruder board the debug red led dont flicker any more.... ist correct ? Sorry. until to now, i have no idea how to fix this problem...... can you tell me more detail how to fix it ?

by tv7957ht - Firmware - mainstream and related support

Uploading 'ArduinoSlaveExtruder' to extruder board error - 15 years ago

Hi. i was just finished my self-building PCB board... w/ motherboard and extruder board. I was completed burn a bootloader for both after that i was follow your instruction and completed to uploading a firmware to motherboard. However when i try to do the same way to upload firmware to extruder board i found this error at arduino IDE - 0018 "avrdude: stk500_paged_write(): (a) protocol error, ex

by tv7957ht - Firmware - mainstream and related support

Re: Problem with soldered motherboard for mendel - 15 years ago

Hi. i was just finished my self-building PCB board... w/ motherboard and extruder board. I was completed burn a bootloader for both after that i was follow your instruction and completed to uploading a firmware to motherboard. However when i try to do the same way to upload firmware to extruder board i found this error at arduino IDE - 0018 "avrdude: stk500_paged_write(): (a) protocol error, exp

by tv7957ht - Sanguino(lolu)

Re: error when burn a bootloader from AVRdude & Arduino IED0018 - 15 years ago

Hi, thank you for your advise.....by the way i also found a page "http://sanguino.cc/troubleshooting" and there also shown a instruction how to burn a bootloader on avrdude and i had solved a problem. However, when i was got this problem I was trying and searching a lot of method and got fail many times, now i had another new problems is i make a wrong way to burn a 2 chip by using a fuse burning

by tv7957ht - Firmware - mainstream and related support

error when burn a bootloader from AVRdude & Arduino IED0018 - 15 years ago

I was build a Sanguino board by myself and when i want to build a bootloader from arduino IDE 0018 and AVRdude it was show error as follows. I'm using a "USBtinyISP" --- and i was follow instruction by reprap site. --- ----------------------------------------------------------------------- When i using "Arduino IDE0018" its shown "Error while burning bootloader." avrdude : Expected signature

by tv7957ht - Firmware - mainstream and related support

Reprap building - 建造Mentel (香港Reprapper) - 15 years ago

剛開始打印Mentel的零件希望香港,中國兄弟們來交流一下.

by tv7957ht - China + RepRap 用户组

Re: 欢迎来自中国的朋友都为 REPRAP 出一份力。 - 15 years ago

你好..我是來自香港我已經入手了一台MakerBot現正嘗試打印Mendel的零件. 有與趣的話可到我blog交流一下

by tv7957ht - China + RepRap 用户组