Show all posts by user
http://reprap.org/wiki/RUG/Greece
Re: Anyone from greece? - 9 years ago
χαιρετώ την Ελληνική κοινότητα! έχω έναν 3d printer Prusa i3 (με frame Graber i3 από plywood) προς πώληση. όποιος ενδιαφέρεται μπορεί να επικοινωνήσει στα: και για περισσότερες πληροφορίες/φωτογραφίες/δείγματα εκτύπωσης κλπby spoos - Greek RepRap User Group, ελληνική ομάδα χρηστών
Re: Bowden extruder infill Problem - 9 years ago
Paul you are 100% right..the z height was the solution to the squeezed first layers! not skipping steps nor feedrate.. i used to have a Z Offset Value at slic3r because the first layer didn't stick well (so i thought i havent calibrated the limit switch - nozzle height well. i use auto bed leveling)..i removed that non-zero value and now it prints well! i am using hairspray for the first layer tby spoos - Slic3r
Re: Bowden extruder infill Problem - 9 years ago
ok thanks for the info.i will try to see if it prints better. another question.. do you know why the first layers of the prints are a little bit squized? did you ever have a similar issue? accordinng to the reprap pictorial it might be high z feedrate or something but i dont think thats it..by spoos - Slic3r
Re: Bowden extruder infill Problem - 9 years ago
When i use specific values of extrusion widths the prints turn out to be really crappy... when i set all these setting to 0 i have good prints (perimeters at least) but i have the infill problem again.. the bidges turn out to be good because i have extreme low bidge speed (5-10mm/s) can you give me specific slic3r settings for a 0.4mm nozzle? if someone has a similar setupby spoos - Slic3r
Re: Bowden extruder infill Problem - 9 years ago
Thank you for your answers, the extruder is geared. i used the gear from standard Greg's Extruder. Is it better to use Mk7 drive gears instead? The steps/mm value is correct for my setup as i measured it a few timesby spoos - Slic3r
Bowden extruder infill Problem - 9 years ago
Hello reprapers, i own a prusa i3 printer with a chinese "e3d v5" head. recently i updated from Greg's to Bowden extruder (teflon tubes 55 cm-pneumatic fittings) and then the problems begin.. i use marlin 1.0.2, slic3er 1.2.9 and repetier host. My main problem (among others..) is that the infill is not correct. The linear pattern strings do not stick together and some blobs are created. Also thby spoos - Slic3r