So I managed to short out the stepper driver to my extruder while adjusting the pot....Does anyone know if it is possible to repair my electronics, or am I going to have to buy a whole new board? I was wondering if the "experimental" pin outs could be used to run an external stepper driver, or if it would be worth my time to try and de-solider the blown driver chip. Jasonby sirsumm - Controllers
I do need to adjust the pots.....the other way. I got the motor mounts soft last night from heat. The motors were running at 90°c rather than the recommended 45-50°. Techzone recently updated the stepper drivers from what I understand, and I am having a bit of trouble getting the pots right. It looks like it is all or nothing when I turn them on. My CNC mill has pinouts that allow me to measby sirsumm - Idaho RUG
Hello, I just started building a Techzone Huxley kit, and was wondering if there was anyone near me that could assist. I have most of the mechanical built, but must have some alignment problems of some sort. My steppers move well, as long as they aren't connected to the belts. Once I connect them, they seem to stall. I am not sure if I have too much binding in my frame, or if Repsnapper needsby sirsumm - Idaho RUG