Hello,- My printer has been working without any problems for a while, but suddenly the heater didn't work. I bought some new resistors, since the old resistor was dead. When using the new resistors (Resistance 6.8ohms 3W) and setting the temperature to 200 degrees C. the resistor gets hot really fast and then it dies. The voltage to the resistor is always 19.56 V, when I set the temperature in pby Nimal - Huxley
Hi,- During a print on my Huxley, the extruder suddenly stopped extruding and the extruder motor was "vibrating" with noisy sound. I checked if the motor was dead by connecting it to the Z-drive, but when doing that the motor works, so it has nothing to do with the motor. I then tried to connect the Z-motors to the E-drive, but I got the same behavior with vibrations and noise. I checked the driby Nimal - Huxley
Hi Ryan,- I am using Skeinforge. When you write "if using slicer" do you mean slic3r? /Nimalby Nimal - Printing
Dear Guys,- I have a Huxley printer and it prints fine, but when I press print in pronterface it takes a while before the printing starts and the heatbed turns off and the heater temperature is only measured. When it then begins printing the heatbed temperature is available but I need to set the heatbed again since it is turned off. Does anyone have a suggestion? /Nimalby Nimal - Printing
Problem Fixed. See for solution.by Nimal - Printing
Problem Fixed. See for solution.by Nimal - Huxley
I moved the wires and it works. THANKS!by Nimal - Huxley
Dear guys,- I just got a new Huxley and it works almost fine, but I have problem when I prints in angles (please see the attached photo). Do anyone have a suggestion to the problem? /Nimalby Nimal - Printing
Dear Guys,- When I press the home button for the X-axis, the X-axis is only moving a little bit to minus X and not to Home. To get the X home I need manually to move it to the endstop, when it’s at the end and I press Home it knows X is Home. Do anyone know, how to fix the problem?, in order not to manually move the X-axis Home, and just press Home. The Y and Z axes Home buttons works. /Nimalby Nimal - Huxley
Dear guys,- I just got a new Huxley and it works almost fine, but I have problem when I prints in angles (please see the attached photo). Do anyone have a suggestion to the problem? /Nimalby Nimal - Huxley