I solved problem with the big gear having air/room/space at the point of the contact with shaft and as a consequence rotating without rotating shaft, by using superglue. It still works. That was a nasty bug, showing as unsufficient volume of extruded plastic, hobbed part skipping, until it stopped extruding at all. That's when i finnaly saw it.by AnMeX13 - Huxley
It would seem you found where is the root of your problem, but forgive me for finding your description lacking. Would you try again, focusing more on the problem ? Perhaps a photo ? It's not as if i expect to know solution, but other people might and your description, excuse me, sux.by AnMeX13 - Huxley
If you want just to print, perhaps you should consider : Not cheap. I printed all Huxley parts on my RepRapPro Huxley, but it took some time, mostly due to non precise assembly. I would recommend you to remeasure all sides, make sure that mirrored lengths are the same, right angles are right, distances are exactly the same, bed is level and so on. I find 0.1 mm to be just about sufficient preby AnMeX13 - Huxley
Ok, here's the dirt : - there was a remainder of white in the hotend, with a nasty feature of being much wider at the top. - bowden tube widened above extruder too and that was blocking it going back I managed to get it out by using a single thread of metalic brush, while having hotend at 190 C. I managed to pull filament out for about 2 cm, then i had to dissasemble hotend and cut away widenedby AnMeX13 - Huxley
Thank you, there's plenty of bowden tube to go aroundby AnMeX13 - Huxley
I was thinking in the direction of dislodging the jam, but didn't want to damage the tube inset, as i don't know what to replace it with. I do have some of the bowden tube, which was too long, causing other trouble, so if it's the same material it's no problem, otherwise i need to order whatever that is. My desperation has not got to the burning stage, yetby AnMeX13 - Huxley
Filament isn't moving out of nozzle. Extruder pulls out as much as elasticy allows and then it's stuck. There is no plastic coming out when heated to 200 C. I tried pulling it out by hand, by motor, no go. I could probably use more force, but i already broke a couple of pieces, so i'm a bit vary. It happened with white, not sure what exactly was i doing, obviously something that ended with reveby AnMeX13 - Huxley
Pred kratkim sem sestavil RepRap Huxley in sem pripravljen stiskat dele za vsak printer, za katerega so dostopne datoteke, po ugodnih cenah. Trenutno imam na zalogi črno in belo plastiko, možni dogovori o drugih barvah z zamikom dostave. Na zalogi imam večino delov za Huxley-a, kmalu vse. Dosegljiv sem na andrej (pika) mejac (pika) x13 (afna) gmail (pika) com ali zs.by AnMeX13 - Slovenia RepRap Developer Group