Show all posts by user
http://reprap.org/wiki/Huxley Huxley is like Mendel, only smaller and cuter.
Re: Problem with reprappro Huxley after updating firmware. - 10 years ago
I found that the thermistor had come loose from the heater bed, so I soldered it back on. Now the temperature is showing correctly, but the heatbed won't heat up. I checked everything and it looks ok, but there is no 19V on the heatbed supply wires. The troubleshoot guides are all for the Melzi board, and I have a Sanguinololu. They seem to be diffently wired when it come to the power supply. Mby Hugis - Huxley
Re: Problem with reprappro Huxley after updating firmware. - 10 years ago
Many Thanks. The reset seemed to do the trick. Now the error is gone, and I can move the bed around again. It seems like the heater on the bed got damaged though, since it doesn't heat up anymore. I will se if i can do a more thorough check... Regards /Johanby Hugis - Huxley
Re: Problem with reprappro Huxley after updating firmware. - 10 years ago
This is my M503 result: Printer is now online. SENDING:M503 echoteps per unit: echo: M92 X91.429 Y91.429 Z4000.000 E875.000 echo:Maximum feedrates (mm/s): echo: M203 X500.000 Y500.000 Z5.000 E45.000 echo:Maximum Acceleration (mm/s2): echo: M201 X1000 Y1000 Z50 E1000 echo:Acceleration: S=acceleration, T=retract acceleration echo: M204 S1000.000 T1000.000 echo:Advanced variables: S=Min feedratby Hugis - Huxley
Problem with reprappro Huxley after updating firmware. - 10 years ago
I got a second hand reprappro Huxley, shipped may 2012. I updated the firmware from the github, and the update went smoothly, but now I get errors when I try to test the printer. The Y axis also got reversed, but i fixed that by reversing the contact. I think there is some kind of problem with the heating system, since I get strange values on the temperature, and when i try to move the printing hby Hugis - Huxley