Do you think this will work?by eggbowl - Huxley
I posted about my Huxley bed not heating properly. I've figured out that it's broken (reading 6 M ohms across--way too much.) I'd like to get a replacement bed, but searching for another 140x140 mm bed hasn't yielded any good results (all out of stock or unreliable vendor) Does anyone know where I can get a 140x140 mm bed? Or if that's not possible, a different size bed that has the same mountingby eggbowl - Huxley
Okay, so here are some images to make things clearer. This shows how the target temp in pronterface spikes up and then goes right down. The bedtemp is sensing properly, it changes when i put my finger on it or take it away The bed end terminals. the wires that (are supposed to) carry the heat are the copper ones in the blue terminal, the 2 black wires are for the thermistor, and the yellow/by eggbowl - Huxley
I have a v0.1 reprap pcb heat bed, and melzi 2.0 electronics. I've unplugged everything except for the bed for testing (everything else works.) Temperature is being properly detected, but when I use pronterface to send a command to heat the bed, the target temp will go up to wherever it's supposed to be, stay there at most a few seconds, and then drop right back down to 0. I have two ideas, one tby eggbowl - Huxley