Hi, Have recently fitted the "Universal Hot - End 3mm Filament" from emakershop to my techzone mendel (with gen 3 electronics). I uploaded firmware which brnrd posted here but with configuration.h modified to use thermistor (thermistor uncommented and other options commented out), and with temperature.h modified to have the correct thermistor calibration table. On running repsnapper generally tby khalid.a.abdulla - Firmware - mainstream and related support
Hi, I have (or at least think I have) install all the dependencies; and the ./autogen.sh appeared to run without reporting any problems and produced the Makefile. However, when running make, which I did using sudo make I get the following errors, and no repsnapper executable is produced: $ sudo make make all-recursive make[1]: Entering directory /home/khalid/Projects/repRap/repsnap2/repsnappeby khalid.a.abdulla - RepSnapper
morrist: I measured 17 megaOhm between the wires of the heater and those of the thermocouple; and the reading from the multi-meter was creeping up so I took this to mean it was an open circuit and it was a limitation of the multi-meter in reading large resistances. brnrd: Thanks for the tip; will get in touch with techzone regarding a replacement extruder controller board and post back about howby khalid.a.abdulla - General