thanks for the reply! i actually was doing a search on RepSnapper and the first entry lead me back here to your response! must be in the cards! For me no, G28 did not produce a response. -karlby Architect - Firmware - experimental, borrowed, and future
Traumflug Wrote: ------------------------------------------------------- > 3200 means 3200 mm = 3.2 metres, so it's far out > of the mechanical capabilities of most (all?) > RepRap machines. You probably run into numerical > limitations with such a command. Try something > smaller than +-600 mm. interesting because i used these commands ok X:0,Y:0,Z:0,E:0,F:400 g1 y10 // y axisby Architect - Firmware - experimental, borrowed, and future
I think I have a bad pin on my arduino. #define X_STEP_PIN DIO4 // AIO0 #define X_DIR_PIN DIO5 // AIO1 #define X_MIN_PIN DIO2 // AIO2 #define Y_STEP_PIN DIO6 // AIO3 #define Y_DIR_PIN DIO7 // AIO4 #define Y_MIN_PIN DIO8 /by Architect - Firmware - experimental, borrowed, and future
working on it now, the last commit was from triffid on the 7th (yesterday) I'm excited to learn (yet another) source control app git :-) I'm also running this from a Linux command line and Triffid provided the shell scripts which mendel_cmd and mendel_talk are used. very nice So the way I left it/Its set right now my config is: #define X_STEP_PIN DIO2 //AIO0by Architect - Firmware - experimental, borrowed, and future
As I go about planning my Mendel build, I've been following this thread with great interest . As it stands, do to the Holidays and kids presents, I have to wait to get my presents. so hardware and parts are coming slowly! regardless, I decided to start looking into the code here and getting it installed on my Duemilanove. I have a couple of easyDriver steppers from sparkfun which run a few NEMA17by Architect - Firmware - experimental, borrowed, and future