Show all posts by user
Support for the quite nice RAMPS Electronics. See also http://reprap.org/wiki/RAMPS.
Re: I need help with RAMPS 1.3 - 13 years ago
I made the test and when I send the z-axis to move 10mm, it only moves 3.8 mm. Is the problem on the firmware? How do I solve this? I'm using the firmware that Jcabrer told me to use before in this forum. I know nothing about settings ... How should I proceed?by Adriano - RAMPS Electronics
Re: I need help with RAMPS 1.3 - 13 years ago
The problem with height of the nozzle solved ... Now I have a new problem... For example .. Printing a 80mm cube, the result is a "cube" 80mm wide x 80mm long x 20mm tall ... How do I correct that? Seems that the axis is not printing all the necessary layers for that, can you help me how to solve it?by Adriano - RAMPS Electronics
Re: I need help with RAMPS 1.3 - 13 years ago
I had never used the Skeinforge to make some ajustments, only the Repsnaper I'm gonna pay attention about the (Z) speed What I noticed is that the nozzle is always touching previous layer.by Adriano - RAMPS Electronics
Re: I need help with RAMPS 1.3 - 13 years ago
The software I use is the Repsnapper .... Once installed the skeinforge I go into skeinforge .. Choose extrusion ... Bottom ... Height over additional layer thickness (radio) where I do the necessary setting Save all ... I open the Repsnapper and do the test print Is this step by step correct?by Adriano - RAMPS Electronics
Re: I need help with RAMPS 1.3 - 13 years ago
Good Morning! My printer seems to be working well, although haven't installed the hot bed yet (came missing in the kit purchased from Botmill) However I'm having the following problem .... When extrussora will print the second layer its nozzle is very close to the first layer, rubbing almost the same ... I don't know how to set, when the it changes the layer, to take the nozzle a little higherby Adriano - RAMPS Electronics
Re: I need help with RAMPS 1.3 - 13 years ago
(jcraber) I would first like to thank you for the detailed explanation. Only today I managed to move the printer and follow the steps mentioned ... Everything seems to work well .... I found that I have burned two stepper driver .. I'll get new ones this week ... so I will install them to make the first tests .... I'll keep informed about the setup process ... Once again I appeciate your helpby Adriano - RAMPS Electronics
Re: I need help with RAMPS 1.3 - 13 years ago
Hi brupje sorry I don't know what is the shield attached? I program the Arduino like this: I open the Arduino program. file Open I select the folder tonokip_firmware933c0b6 ... then configuration.h To conclude upload The Tx and Rx lights Arduino and the LED flash Ramps ... Don't make any changes to the firmware ... I don't know what to do And this process should I do? About Botmill, it's beenby Adriano - RAMPS Electronics
Re: I need help with RAMPS 1.3 - 13 years ago
Good morning, I appreciate your help ... The operating system that I´m using is Windows Vista Home Premium, Repsnappe_v352 the firmware . Arduino0022 ... I know nothing about the program, if you could describe step by step how to solve this problem .. thanks Adrianoby Adriano - RAMPS Electronics
I need help with RAMPS 1.3 - 13 years ago
I bought an Axis Kit from Botmill, it came with RAMPS 1.3. It's all set but doesn't connect. I'm having problems to install the software. When I connect to Repsnaper, the motors make a little noise, but nothing move. Can anybody help me?by Adriano - RAMPS Electronics