Hello, I downloaded a few days ago the latest files from github. I just noticed that the x end idler and motor are in mirror. Normally the x end motor should be on de left it is now on de right. The moto should be on the frame side but is now on the bearing side. Has anybody noticed this? Check this stl from github translate([0, 0, 0]) mirror([1, 0, 0]) translate([0, 0, 0]) x_end_motor(); Ifby martijnr17 - General Mendel Topics
I have for sale the printed parts for a Prusa mendel 2. I also sell them on ebay but you can also buy them directly from me. If you want to buy directly just send me an email to the address that's in my profile. A set will cost €50. Sending in the Netherlands will cost €7. Sending to other countries in Europe wil cost €18,50 Normally I will send them without the bushings because it's better to uby martijnr17 - Plastic RepRap Parts for Sale
I think i have solved the problem. In my hot end the cold part was to hot. I have addes some extra coolsink plate and now the problem is gone for now. The printer is now test printing PLA in everything goes okay at the moment. I'm printing some extra gears for the wade extruder incase they break I have spare. I'm very happyby martijnr17 - General Mendel Topics
I have made a new hobbed bolt and printing goes better now. It's frustrating that everything works but only the extruder or hot ends stops working. Maybe is my home build hot end not good enough but i'm still waiting on the hot end from mendel parts.by martijnr17 - General Mendel Topics
I have measured it with a multimeter. And when i have set the temp to 200C it is about 215 to 220. I Tried printing with about 220 degrees but in reality it is 240. Will try printing with 205 degrees and tell you how it goes.by martijnr17 - General Mendel Topics
I've already measured with a multimeter, and that gives about the same temperature as the hotend itself. Will measure again tonight.by martijnr17 - General Mendel Topics
I'll try to borrow a IR reader from my work, then I can measure the right temp hopefully. On the peek i have constructed some small metal blades and a small fan to cool it down. I'm trying to print the first layer with a higher temp so that it stick better...because i'm still waiting for kapton tape. I have a heated bed at 110 to 120 degrees with which was available at my work but it doenst stiby martijnr17 - General Mendel Topics
I'm using wades extruder with a homemade hot end. When I print abs with a temp of 220c degrees there is no problem, but when I set the temp to 230 degrees there is no feed out of the hot end???? Has anybody an idea how to solve? where the problem could be? Kind regards,Martijnby martijnr17 - General Mendel Topics
It's indeed de kliment sdramps. Maybe I have to wait a little bit more, I have my raprap just a week and everything is new for me. If I understand it right I can enter gcode in Repsnapper and send it. I can upload the gcode file by a usb reader or directly(usb reader is easier I think) and send the load and start codes to start printing and can turn the computer of. The only thing I have todo isby martijnr17 - RAMPS Electronics
I have bought the sdramps diy kit. Can somebody tell me how to connect it to the ramps board? Can is connect it tot ext3? I also have seen a picture when it was connected to ext4? I use rapsnapper on windows r351 Windows x86 how to set it up to use the sd card? There is very little documentation about de sdramps or can somebody give a link? Kind regards, Martijnby martijnr17 - RAMPS Electronics