Show all posts by user
Support for the quite nice RAMPS Electronics. See also http://reprap.org/wiki/RAMPS.
Re: Ramps 1.4 Breakout Shield - Ethernet Shields - 11 years ago
Those that wish to use the Hotend we created will use custom USB cables. There are different connectors to use but we chose the USB type connector for a few reasons, the cable itself would be larger AWG and have a custom colored loom. When using a double extruder, we will be upgrading for a different connector. As for the Ethernet, in it's stock 24 AWG wiring, the stepper motors we use, we do notby UniverseUnlimited - Crowdfunding Projects Announcements
Ramps 1.4 Breakout Shield - Ethernet Shields - 11 years ago
Good evening all, I thought I would post up some information regarding the Ramps 1.4 Shield on Kickstarter. Ramps 1.4 Breakout Shield I would just like to point out and confirm that I am the creator behind the project. My intentions behind the project were focused on using a viable piece of hardware that got me involved with 3D Printing many years ago. While many think that Ramps 1.4 is outdateby UniverseUnlimited - Crowdfunding Projects Announcements
Re: Makerbot Endstops / Wiring Kit / RAMPS 1.4 mismatch - 13 years ago
I have the same issue, here is what you need to do. BTW, Thanks for posting this because of what you did, I figured out what I need to do. I'm using Sprinter BTW. Don't solder anything. 1. Instead, take the 3-pin harness from the kit and remove the wires by lifting the three tabs. 2. Place some heat shrink over the YELLOW, BLACK AND RED wire and expose some of the colored wired so you caby UniverseUnlimited - RAMPS Electronics