I replaced mine with theseby Falcondestroyer123 - RAMPS Electronics
Hey guys i want to buy a aluminum plate as a replacement for glass but is 4mm good enough? Where is a supplier which i can get in Australiaby Falcondestroyer123 - Reprappers
Hey guys, I recently had a melt down of mosfet and the D10,D9,D8 got melted and i can't fin replacement parts. I want to buy a single component so not bulk please and Im in Australia Or could i stack 2 of theseby Falcondestroyer123 - RAMPS Electronics
Hey guys What is the difference between v1 and v2 on the circuit board.by Falcondestroyer123 - RAMPS Electronics
So adding a external mosfet is the best option right and then do i need 2 psu and what output do i need planning to run a 24v bed on ramps 1.4.by Falcondestroyer123 - RAMPS Electronics
Hi, Is this a good way to do it?by Falcondestroyer123 - RAMPS Electronics
In Australia everything is more expensive then the usby Falcondestroyer123 - Stepper Motors, Servo Motors, DC Motors
The thing is that nema 17 steppers are still expensive still from chinaby Falcondestroyer123 - Stepper Motors, Servo Motors, DC Motors
Hey guy this is going to be a stupid question. I live in Australia and where are the cheapest nema 17 motors? Please help.by Falcondestroyer123 - Stepper Motors, Servo Motors, DC Motors
Hey guys i need help which thickness of heated bed. Is 2 mm the standard thickness of a 300x300 mk2a heat bed. Also what is the resistance of a 300x300 24v bed. Thanksby Falcondestroyer123 - General
Could i use a hacksaw and a mitre box to cut the extrusionby Falcondestroyer123 - Extruded Aluminum Frames
ok thanksby Falcondestroyer123 - Extruded Aluminum Frames
Hey guys I wondering if anyone tried cutting Extrusion by hand with a hacksaw. If one of you guys did it please tell me how straight it would be and how ruff. Thanksby Falcondestroyer123 - Extruded Aluminum Frames
Could i just use a 12v 30a psu as the same psu in the creality3d cr 10.by Falcondestroyer123 - Reprappers
What are the differences for the orange and black heat beds and which is better?by Falcondestroyer123 - General
Could the I mod the Ramps 1.4 to 24v and will the arduino board handle that voltage?by Falcondestroyer123 - Reprappers
HI everyone would a 24v heated bed work on a Ramps 1.4 a with a Arduino Mega 2560. Thanksby Falcondestroyer123 - Reprappers
Does it Matter if i use the Ramps and Arduino board for a printer bigger then 200x200 and the Rambo and the Mks board seem expensive for a homemade printer in my opinion.by Falcondestroyer123 - Reprappers
So Guys what is the final answer for the wattgeby Falcondestroyer123 - Reprappers
Hey guys im planning to build a printer with the arduino 2560 mega and ramps 1.4 board and using a mk2b 300x300mm heat bed and with a lcd what wattage of a power supply do i need. Thanksby Falcondestroyer123 - Reprappers