Hi everyone! I’m new here and someone pointed out that I accidentally posted this on the wrong board, I’m not sure how to move a topic so ill just post the question here and link back to the old topic! I’m working on converting an old Da Vinci pro 1.0 to a MKS Base 1.4 running the Marlin Firmware. Everything is working fine but the display and control panel. How would I configure Marlin to worby ILikeToEatYellowSnow - RAMPS Electronics
Is there any way to move this thread to that board?by ILikeToEatYellowSnow - General
As you can see, I’m new here; I had no idea that there was a dedicated thread. Thanks for pointing that out! Il try to post my questions in a better place next time!by ILikeToEatYellowSnow - General
The use of all buttons would be optimal but could wait for now I guess. I would still want to have one button for "Home" and one for "Enter". How are the "ZONESTAR_LCD” button configured and how do they correspond to the EXP1 pinout? By inspecting the schematic of both the MKS Base 1.4 (Screen2.png) and ZonStar (screen.png) the EXP1 pinouts do not correspond to each other. I thought it was a unby ILikeToEatYellowSnow - General
Yes that is correct the original board for the Da Vinci uses the buttons as individual inputs. All have a individual Pull Up resistor that is 100K if I’m not mistaken (I’m not home at the moment so I can’t check my PCB files) It would be more practical to use them all on a single input of the ATmega2560 because then id only have to use one cable from EXP1. Not really sure how id go about implemenby ILikeToEatYellowSnow - General
Hi everyone! So I recently got my hand on an old Da Vinci Pro 1.0 3in1 (My work was going to throw it out). The printer didn’t work well so I decided to retro fit the electronics. I’ve replaced the main board with a MKS Base 1.4, replaced the hot end to an E3D V6 hot end and added a raspberry Pi 3 with OctoPrint inside the electronics compartment! Now I want to use the original LCD and buttonby ILikeToEatYellowSnow - General