I have Ender 3 and wanted to install a better motherboard with bootloader and more memory .I bought MB and it came with Artillery 3D firmware flashed on the board . I installed the drivers 2208 and set Vref. When I tried to flash compiled version of Malin 1.1.9 board did not recognize any of my COM ports. The Tools COM ports in Marlin is grayed out. So far I belong to several different facebook fby Buster - RAMPS Electronics
My first post I have installed original BLTouch on my Anet A 8 M printer . The probe moves on the lest side of the build plate OK but the middle and right hand side are 27 mm short from the end of the build plate. The build plate is 220x220x240 .I am using Marlin 1.1.9 any help would be appreciated .by Buster - Firmware - Marlin
I would like to ask if someone could tell me what motherboard I have on my new Anet printer.I would like to update to new Marlin.by Buster - General
I have a problem with Marlin flashing my mother board when I try to verify Marlin I get a error message. #endif / / BED_LEVELING. What did I miss?It said #endif without #if ? I added full error page,by Buster - Firmware - Marlin