I'll give it a go. Thanks.by tc1967uk - Repetier
Hi Total 3D printing newbie here, apoloies in advance if my terminology is wrong. I have a dual head K200 delta printer with a heated bed which I put together 8 months ago, but gave up due to frustration of the following error in Repetier: temp sensor defect marked defect Errorrinter set into dry run mode until restart! I've tried again today, and all 3 thermistors (and the spare) work fine,by tc1967uk - Reprappers
Hi Total 3D printing newbie here, apoloies in advance if my terminology is wrong. I have a dual head K200 delta printer with a heated bed which I put together 8 months ago, but gave up due to frustration of the following error in Repetier: temp sensor defect marked defect Errorrinter set into dry run mode until restart! I've tried again today, and all 3 thermistors (and the spare) work fine,by tc1967uk - Delta Machines
Hi Total 3D printing newbie here, apoloies in advance if my terminology is wrong. I have a dual head K200 delta printer with a heated bed which I put together 8 months ago, but gave up due to frustration of the following error in Repetier: temp sensor defect marked defect Errorrinter set into dry run mode until restart! I've tried again today, and all 3 thermistors (and the spare) work fine,by tc1967uk - Controllers
Hi Total 3D printing newbie here, apoloies in advance if my terminology is wrong. I have a dual head K200 delta printer with a heated bed which I put together 8 months ago, but gave up due to frustration of the following error in Repetier: temp sensor defect marked defect Errorrinter set into dry run mode until restart! I've tried again today, and all 3 thermistors (and the spare) work fine,by tc1967uk - RAMPS Electronics
Hi Total 3D printing newbie here, apoloies in advance if my terminology is wrong. I have a dual head K200 delta printer with a heated bed which I put together 8 months ago, but gave up due to frustration of the following error in Repetier: temp sensor defect marked defect Errorrinter set into dry run mode until restart! I've tried again today, and all 3 thermistors (and the spare) work fine,by tc1967uk - Repetier
Hi Dust Total 3d printing newbie here, sorry. Had the thing over 8 months and never got it going. I'm having the same problem: - temp sensor defect marked defect / Errorrinter set into dry run mode until restart! When you say unplug the thermistor, which bit is that, where in Repetier would it say 0ish, and where would I find the ADC pin? Sorry to bombard you with questions.by tc1967uk - Firmware - mainstream and related support