Thanks Dustby cabped - RAMPS Electronics
Hello guys, I need to wire both ESP8622 and touch panel JZ-TS35 to RAMPS1.4. Those two originally uses AUX1 (5v GND D0 D1) working pretty fine alone, so I need to wire one of them on other Serial port to use them together , but I don’t know which on to use (AUX2, AUX3....), and also which pins to use for communication as TX RX (D41, D43...). Could you guys help me? Thanksby cabped - RAMPS Electronics
Actually, the auto leveling works with a metallic pin which is dropped down as the carriage touches the side of the x axis outside the print area. Then, the z axis moves the bed until it touches the metallic pin and lift it up some distance (until the pin reaches the optical sensor). After mesuring 9 point on the bed, the pin is lifted up by moving it to outside the printing area over the glass hby cabped - Firmware - Marlin
Roberts_Clif, Thanks for the quick response. The model is GTMAX3D Core A1 (2016). As I said it’s a brazilian manufacturer. M503 results: M503 echoteps per unit: echo: M92 X80.00 Y80.00 Z400.00 E374.40 echo:Maximum feedrates (mm/s): echo: M203 X200.00 Y200.00 Z50.00 E100.00 echo:Maximum Acceleration (mm/s2): echo: M201 X2000 Y2000 Z1000 E3000 echo:Accelerations: P=printing, R=retract and T=tby cabped - Firmware - Marlin
Hello Guys, I have a 3D Printer made in Brazil which uses Marlin Firmware version 1.0.6, and I need to do some firmware changes as, for instance, enabling filament runout detection. Once I need to change the firmware I would also like to upgrade Marlin Firmware to the latest version 1.1.9, enabling also the improvements of that version. The problem is: I don't have the parameters to set up theby cabped - Firmware - Marlin