QuoteDust "12V supply to power the RAMPS" there are two power plugs the 5amp and 11amp circuit Which did you power up? the steppers are on the 5amp side. i think i hsve connected the right one(the 5amp side). Is there any way that we could identify ifthe problem is with the software\firmware side or with the hardware side ? Attaching the snippet of connection i made which has only one Moby knn7 - RAMPS Electronics
Dust , we are using a 12V supply to power the RAMPS and been using A4988 Stepper driver. Attaching the snippet of the connectionby knn7 - RAMPS Electronics
Hi Dust, I've made the changes on Y_ENABLE_ON as zero as below #define Y_ENABLE_ON 0 And tried again, still getting the same response ie the motor and Pronterface doesnt respond on passing G1 Y10 F1200.by knn7 - RAMPS Electronics
@VDX thnkyou for the insight! yes the motors are powered and can you like suggest any recommended values for the same?by knn7 - RAMPS Electronics
@Ohmarinus Thnkyou for having a look into this. I am trying to build a custom 3D-Printer of my own. And i have been testing with only the boards and motors connected to X and Y(Noting else is connected like endpoint triggers or thermistors). And the config file i used are from Marlin(1.1.9.1) without any modification(PFA). The steps per unit is defined as "#define DEFAULT_AXIS_STEPS_PER_UNITby knn7 - RAMPS Electronics
@Dust Thankyou for looking into this. I tried passing M119 which gives me the following results.- SENDING:M119 Reporting endstop status x_min: TRIGGERED y_min: TRIGGERED z_min: TRIGGEREDby knn7 - RAMPS Electronics
Hi Guys! I'm new to the 3D printing world, and trying to get make a printer of my own :-) So, I purchased all necessary electronics and mechanical parts, and now am trying to figure out the software. To do so, I uploaded the Marlin(1.1.9.1) firmware onto my RAMPS 1.4 board. For testing the software basics before getting the components into the structure, I am testing with the following componeby knn7 - RAMPS Electronics