After some more digging into this, I can confirm that it is a manufacturing issue. Somewhere in the process, + and - on servo's is getting some type of debris across them. I have ordered roughly 50 boards from various sellers and all have been the same, a direct short across + and -. I have communicated this to all sellers that I ordered from. I have noticed the most have pulled the products butby allen476 - RAMPS Electronics
This is a bizarre issue. Everything was working fine until a month ago. I upgraded to ramps 1.6 after my 1.4 board decided it wanted to go to the big chip in the sky. I ordered a kit to replace the 1.4 and the 2560. Everything was working fine. I notice my prints are quite a bit better. I then do a complete overhaul of the printer. New rods, bearings, belts, and a new Y axis motor. Another testby allen476 - RAMPS Electronics