It depends on the motor specs and driver specs If you series the motors, the required voltage doubles while the current remain the same as if one motor is running. Doing it in parallel, the voltage required is still the same as running one motor but the current requirement is now doubled So you need to think what are the voltage and current requirement of the motor and if doing either series orby joeglens - General Mendel Topics
Check out E-gizmo, i remember they are selling t-slotsby joeglens - Philippines RepRap User Group
f3rDz Wrote: ------------------------------------------------------- > i finally got everything complete. including a hot > end for the 1.7. i've tested the heater block > using a 6.8 resistor - carbon type. didnt last for > 20 minutes. asked a techie friend why is that so. > i was told that i should look for a nichrome type > resistor. spent the whole day last saturday in >by joeglens - Philippines RepRap User Group
@f3rDz its been too long since i checked e-gizmo prices, but they are the only game in town that I know and maybe they are taking advantage of this and monopolizing the market. Alexan is the close competitor but they mainly sell components and servo motors, i didn't find any stepper motors on their website JoeMoneyby joeglens - Philippines RepRap User Group
Try sourcing out from e-gizmo. they even have arduino boards They are located at 2nd Floor, VSC Building, 2313 Taft Ave., Malate, Manila.by joeglens - Philippines RepRap User Group
i might try that also but using a Hi strength adhesive spray. Can't wait to try it tomorrow at the shopby joeglens - General Mendel Topics
Here is another mendel frame design that can be built using only a handsaw and drill pressby joeglens - Philippines RepRap User Group
@bjportega what is your frame made of?by joeglens - Philippines RepRap User Group
Yo, Im from Mahoning county Just built a working reprap... got my kit from botmill except for the electronics which i got from mendel-parts.com... still fine tuning skeinforge to have a clean and higher quality printby joeglens - Ohio, Dayton RepRap User Group
I would really like to buy this but a I have a concern about Botmill's reputation on purchase order processing.by joeglens - General Mendel Topics
Anybody here ever bought a fully assembled mendel from botmill? Is the quality good?by joeglens - General