Zeige alle Beiträge eines Teilnehmers
Gen 5,6 oder 7? AVR oder ARM? Ramps oder Rumba? Megatronic oder Rambo? Hier geht's um Fragen zu verschiedenen Reprap-Elektroniklösungen und einzelnen Bauteilen aber auch um Netzteile, Relais und die Verkabelung.
Seite 2 von 2 Seiten: 
12
Ergebnisse 31 — 38 von 38
12
Re: Heatbed not recognized - 12 Jahre zuvor
Have you enabled the heatbed in the config tool?von mundsen - Repetier
Re: Shift in Z-axis - 12 Jahre zuvor
repetier - ok - Why use E2, and not swap drivers? chngyian - is it normal that the motors get hot? On a small print like this?von mundsen - Repetier
Re: Shift in Z-axis - 12 Jahre zuvor
My motors do not get hot at all, so I do not hink that is the problem. Have swapped stepper drivers on the Y output With one of the unused ones. I`ll do a New test later today.von mundsen - Repetier
Shift in Z-axis - 12 Jahre zuvor
Hi! I have a ORD BOT Hadron + Rumba Controller + Bulldog Extruder + E3D-V5 + 64A + hotend Running the latest Repetier firmware + Repetier Host. This is a New printer that I `m trying to configure/fine tune. I have made a simple qube 20x20x20mm in sketchup that I have printed using Repetier, and the printed result is fine and the qube meashures 20x20x20mm +/- 0,0xxmm But then I made a larger testvon mundsen - Repetier
Re: Using Dual Z drivers + dual extruders on the Rumba board running repetier? - 12 Jahre zuvor
Have started trying the Repetier code. Setting up dual Z drivers was wery simple :-)von mundsen - Repetier
Re: Using Dual Z drivers + dual extruders on the Rumba board running repetier? - 12 Jahre zuvor
I`ll test repetier this weekendvon mundsen - Repetier
Re: Using Dual Z drivers + dual extruders on the Rumba board running repetier? - 12 Jahre zuvor
That configuration page was impressive :-) Now I have to test Repetier firmware.von mundsen - Repetier
Using Dual Z drivers + dual extruders on the Rumba board running repetier? - 12 Jahre zuvor
Anyone here using the Rumba board from reprapdiscount? I`m building my ORD BOT Hadron using this board + Bulldog Lite extruder. I have studied the Marlin firmware and got X,Y and Z axis + extruder + end stops to work fine. But I plan to use dual drivers on the Z axis (one for each stepper) + dual Bulldog Lite extruder setup and have some problems finding how to configure this in Marlin. Is thisvon mundsen - Repetier
Seite 2 von 2 Seiten: 12
12