Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Are you using ABS or PLA?
by
cokezero91
-
Printing
Thought this would be useful for anyone else who was having the same problems.
Temperature was a little a hot and I found this technique to be the most useful way of determining the correct temperature: "Start by doing a simple extruder test to determine what the range of temperatures are that you can extrude at. Reduce the temperature in 5 degree increments until the extruder starts skipping wh
by
cokezero91
-
Printing
Nozzle Size: 0.34 mm
Layer Height: 0.25 mm
Width: 0.4mm (the one under the layer height in sfact)
What width setting would you recommend changing to?
by
cokezero91
-
Printing
Hi All,
I have just bulit a prusa mendel, and I am using HW: Ramps 1.4, SW: Pronterface => SFACT.
I seem to be having problems with infill, as can be seen in the attached picture. (best described as mounds which don't connect together well.
E-steps has been calibrated, and infill is set to 0.35 in SFACT (default setting).
Any help would be greatly appreciated.
Thanks.
by
cokezero91
-
Printing