Show all posts by user
Printing issues ...
Re: Prusa i3 printer is not in the right size - 11 years ago
Quoteianmcmill As Putzer said -> Calibration. Did you calibrate the axis well? Also I have never printed in ABS (I hate the warping issues and my heated bed never reaches 100°C) I have heard that ABS prints often suffer from shrinkage. I had the same problem, but I have solved with a silicone hot plate (220V) and a Solid State Relay Now I have no problems. I print on a plain sheet of glassby Hni-DK - Printing
Re: Prusa i3 printer is not in the right size - 11 years ago
QuotePutzer Maybe x and y calibration in Marlin. Excuse me, but I can not see that it makes any difference Marlin or Repetier Hostby Hni-DK - Printing
Prusa i3 printer is not in the right size - 11 years ago
Hi everybody! I have a small problem with my Prusa I3. I print a square that is 100 x 100 x 5mm (ABS) The height fits 5mm But it measures only 99.5mm in x and y All parameters match: "Belt Calculator Repetier Host" Pulleys screws are tightened. Stepper motor should have the right current They do not lose steps. The Printing speed I have set down to 40mm / s Belts I tightened up a bit, I dare noby Hni-DK - Printing
Re: Rostock calibration problem - 11 years ago
Hello! they were drilled when I bought them, and before I replaced the moving plastic parts, there were no problems. I made a 3D PDF. Corner at the X is in 0mm over my glass plate The other is deeper. ??? I have tried to adjust the screws to the limit switches. But I see no Symmetria in the result. I think I remove all the parts and measure them. There is perhaps one that is crooked ??? I'by Hni-DK - Printing
Rostock calibration problem - 11 years ago
Hi All! I have a problem I can not solve. My moving plastic parts were getting worn down so I have printed new parte for my Rostock delta 3D printer. Platform internal measurement between diagonal rod = 67mm. Carriage internal measurement between diagonal rod = 67mm. Here is the calibration data are from the old parts. Delta radius = 126 There is 50mm. between each measurement:by Hni-DK - Printing
Re: Limit switches do not work (solved) - 11 years ago
Have solved the problem! See this page: /* This file is part of Repetier-Firmware. Repetier-Firmware is free software: you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation, either version 3 of the License, or (at your option) any later version. Repetier-Firmware is distributed in theby Hni-DK - RAMPS Electronics
Limit switches do not work - 11 years ago
Hi All! I finished building it and is about to calibrate it. Data: Delta 3D printer. Repetier-Cough V1.0.6. Ramps 1.4 Full Graphic smart controller Endstop X = X min switch on GND, normaly closed Endstop Y = Y min switch on GND, normaly closed Endstop Z = Z max switch on GND, normaly closed When I start it up, and tells it to drive home, so it does not stop when it hits the end stops, then tby Hni-DK - RAMPS Electronics