Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Turned out it was the Z axis. One of the nuts on the threaded rods were popping out of the X axis motor mount bracket.
Thank you all for the help and advice.
by
astrah
-
Printing
Thanks for the advice. I think the parts are coming up short. I'll double check the z axis and adjust if necessary then reprint the part.
by
astrah
-
Printing
Hi, very new to 3D printing but think I am getting there. I was printing a replacement bracket for my Mendel but the bolt holes keep appearing as oval and not round. I have tried a couple of other prints and the same thing happens to them. I have re-calibrated my axis but the problem is still there.
I'm using a Bowden extruder, 0.4 hotend and the Z axis are 5mm threaded rods.
Thanks in advance
by
astrah
-
Printing