Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
same bad experience had to go through a bunch of crap to get a refund
by
phil3d
-
Printing
I spent a few months trying to figure it all out, a complete nightmare. save the headache, delete the old Arduino ide and all the extra junk.
Use PlatformIO to compile, Atmel Flip to program
or if you have a printrbot don't do any of it and use my marlin 1.1.9 firmware
by
phil3d
-
Reprappers
nobody interested in sticking it to the man? ie Stratasys and ripping these bad boys apart?
I may be getting my hands on a u print that thats broken, perfect candidate for conversion as I would have a working uprint as reference
by
phil3d
-
General
Look what I just found!!! 132 Page thesis on Open-Source Converstion of Stratasys FDM Vantage X
by
phil3d
-
General
what really interests me about the stratasys is the way they manage the dual nozzle setup using a single stepper motor.
when the printer needs to switch material the print head moves to the back of the gantry, wipes the nozzle then moves to the right or left corner. A lever sticks out the side of the print-head which gets pushed moving the desired nozzle into position.
More info on the stepper
by
phil3d
-
General
we have a stratasys u print se plus..
its a piece of crap due to its closed source hardware and cost of filament. the software is horrible! its called catalyst I have version 4.4 installed.
you get only a few options for print quality all of which ensure that as much support material as possible is used.
It does not have a heated bed, it has a heated build chamber.
print beds cost $5 each.
y
by
phil3d
-
General