Show all posts by user
Printing issues ...
Re: Undersized circles - Has this been solved yet? - 9 years ago
I don't know if somebody already suggested this, but if the holes are constantly too small (for example always .5mm), there's a setting called "Dimensional Accuracy" or "horizontal size compensation" or smth. like that in most of the slicers. If your holes are always .5mm too small, try typing in -0.25mm (so just half of the amount that they are too small) If your holes are too big then do the saby Farnomat - Printing
Re: printing issue - 9 years ago
I had that as well... It was just bad filament. Do you have other filament spools of other brands? If so, try printing with that and see if it helpsby Farnomat - Printing
Re: Z-Probe Off Set Problems - 9 years ago
Did you try moving the sensor up? It could be that he is too close to the build plateby Farnomat - Printing
LCD 12864 weird problems - 9 years ago
Hi RepRap-Community So I recently bought an LCD 12864 for my DIY CoreXY printer. Today I hooked it up to the Ramps 1.4 board, installed the Marlin firmware and got it to (kinda) work. The only problem is, that after a time staying on the whole screen shifts to the right and comes in on the left side again. It's probably hard to understand but i think it's a hardware problem, not a software probleby Farnomat - Printing
LCD 12864 weird problems - 9 years ago
Hi RepRap-Community So I recently bought an LCD 12864 for my DIY CoreXY printer. Today I hooked it up to the Ramps 1.4 board, installed the Marlin firmware and got it to (kinda) work. The only problem is, that after a time staying on the whole screen shifts to the right and comes in on the left side again. It's probably hard to understand but i think it's a hardware problem, not a software probleby Farnomat - General