Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 8 of 8
I've tried re-slicing it, but the only difference was moving the part to the side, so I'm not sure if that was enough to force a significantly different gcode.
by
TheOrvinator
-
Printing
I haven't tried that, it intimidates me a bit because I've never used any but Cura before. Cura has been working great for me, up until this issue, though.
by
TheOrvinator
-
Printing
I forgot to add what the actual problem is!
The filament just stops extruding, and the printer carries on printing nothing until the part finishes.
by
TheOrvinator
-
Printing
Hi guys,
Thanks in advance for your help! I have a Hictop 3DP-12 Prusa i3.
I've been trying to print a certain part, and it prints beautifully up until a certain point towards the end of the print. This is a point where there is a series of small extrusions being made.
So far, I've tried:
- Replacing hotend cooling fan
- Replacing part cooling fan
- Replacing controller board
- Changi
by
TheOrvinator
-
Printing
Hey guys,
My Hictop 3DP12 i3 Prusa was working great for several months, and I've enjoyed it. Just for a week now, it continues to jam after 10-30 minutes into a print. The nozzle will clog, nothing will come out, and the machine will go on without pushing any filament out. I've looked through many forums and tried all their suggestions, but none have worked so far. I have replaced the jet fan,
by
TheOrvinator
-
Prusa i3 and variants
Hey guys,
To update, after waiting for 4 weeks for a replacement switch (embedded in the cage) from HICTOP, I finally received it, installed it, and found that it completely solved the problem! Thanks for the help.
by
TheOrvinator
-
General
Ok, finally got a voltmeter and poked a bit. Turns out, the signal stops right after the power switch on the control board! I'm hoping HIC will replace the switch. In the meantime, can I simply just bypass the switch and wire the power supply right into where the switch would connect?
by
TheOrvinator
-
General
Hi guys,
I have a HIC Prusa i3 3DP-12. This is my first time working with a 3d printer, and so far it's fun! After assembly, I printed 2 parts with no problem and was very pleased with the quality. However, the 3rd part was estimated to take 5 hours, so I started it and left it. I could have sworn I heard some clicking while I was gone, but it didn't register in my mind, and I honestly may have m
by
TheOrvinator
-
General