Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Hopefully that fixes it for you. In my case my Z axis is actually a 12mm Ballscrew.
by
Cosmic52
-
Printing
To be clear, I am talking about these horizontal lines
by
Cosmic52
-
Printing
I have been having this problem and I am unable to figure out what is causing it and was hoping someone could help me.
As you can see in the images below every couple of mm there seems to be some lines that appear on the part that is being printed. I am unable to figure out what is causing this (Mostly I think it is a hardware problem but has anyone had a similar issue).
Any help would be appre
by
Cosmic52
-
Printing
Quoteruggb
post a pic of your complete hotend carriage. The piezo requires very little movement to produce an output and maybe there is a solution.
Unfortunately I am unable to as the printer is currently in another country and I do not have any images of the hotend. But the mount is the same as shown in the picture and I plan on machining a new mount to incorporate the piezo sensor
by
Cosmic52
-
General
QuoteMoriquendi
QuoteEd3D
Ok sounds good to me. If you could stop making me want to buy more printer related things that would be great though
But then you wouldn't be giving me any money...
QuoteEd3D
I've only really briefly looked into the piezo - I assume there will be some good mount ideas kicking around on the internet. Ill be probing onto glass if that matters?
There are all sorts of
by
Cosmic52
-
General