Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Hello friends:
As the title says, my printer is far away from the extruder, and it still cannot print normally, even though I have already leveled the bed.
In fact, even if I put the nozzle as close as possible to the hot bed (0.1mm) before printing,
still have to stay away from the hot bed when printing. I don't know where this is going wrong.
please help me.
by
guxiao
-
CoreXY Machines
Hello friends:
As the title says, my printer is far away from the extruder, and it still cannot print normally, even though I have already leveled the bed.
In fact, even if I put the nozzle as close as possible to the hot bed (0.1mm) before printing,
still have to stay away from the hot bed when printing. I don't know where this is going wrong.
please h
by
guxiao
-
Printing
Hello Dust:
thank you for your reply!
It has been solved. The main reason for this problem is that I set the automatic cooling fan of the extruder, I lowered the fan speed, and increased the minimum temperature for triggering operation.
by
guxiao
-
Printing
Hello everyone
I just installed a new CoreXY 3D Pringer, and I haven't started printing yet, but now there is an error. I don't know what caused it.
I only have one extruder, E0, but report E1 error.
It can be heated, but it will be thermally protected when it is greater than or equal to 160 degrees Celsius, and report an error:
Heating Failed :E1
PRINTER HALTED
Please Reset
I replaced mul
by
guxiao
-
Printing